111-701-062N VW Beetle & Super Beetle Right Floor Pan w/ Rails (1971-1972)

VW Complete Right Floor Pan Half – 111-701-062N

The 111-701-062N is the passenger-side companion to the 111-701-061N, offering a full-length replacement for the right floor section of your air-cooled Volkswagen. This panel is stamped from high-quality steel and is engineered to match the exact floor configuration of the 1971–1972 model years. It provides a solid, rust-free foundation for your interior while restoring the structural rigidity of the chassis.

Just like the left side, this pan is distinguished by its factory-welded "T" style seat rails. These tracks are specific to the 1971–1972 seating update and ensure your passenger seat slides and locks correctly without the need for custom fabrication. The pan includes all the necessary stampings for drainage and battery placement (on the right side), along with the rear jacking support and outrigger reinforcement.

Detailed Vehicle Compatibility This floor pan is specifically for models with the 1971–1972 seat track design:

VW Beetle (Standard):

• 1971, 1972

VW Super Beetle:

• 1971, 1972

Product Highlights & Features

• Factory-Correct Stamping: Features the original ribbing and contour patterns to ensure proper fitment with the center tunnel and heater channels.

• Pre-Welded "T" Rails: Comes with the 1971–1972 specific seat tracks already installed, saving significant time during the restoration process.

• Integrated Jacking Point: Includes the critical rear outrigger and jack receiver, restoring the vehicle's original lifting points.

• Battery Tray Section: The right side pan features the reinforced area and specialized stampings required to securely mount the battery under the rear seat.

Technical Specifications

• Part Number: 111-701-062N

• Side: Right (Passenger Side)

• Material: Heavy-Gauge Steel (Typically 18ga or 20ga)

• Finish: Black Protective Coating (Weld-through/Shipping Primer)

Installation & Maintenance Tips

• Verify Alignment: Before final welding, "dry-fit" the pan to the chassis and body. Ensure the bolt holes align with the heater channels and the rear cross-member.

• Surface Preparation: Strip the black shipping primer from all weld sites to ensure clean, strong welds. Use a weld-through primer on the bare metal surfaces that will be overlapped.

• Rust Prevention: Once welded, seam-seal all joints and apply a high-quality undercoating or chassis paint to both the top and bottom of the pan to prevent future corrosion.

• Battery Area: When installing the battery on the new pan, ensure you use the proper battery hold-down clamp and a plastic tray to prevent acid from damaging your new steel.

111701062N